I was writing a cel script to show Earth coordinates, and at a point I needed to switch ON/OFF two different Reference Marks, Sun direction and Terminator.
But I found that cel scrips have no command line for this, while celx scripts have it!
So I contacted Selden who very kindly found a celx script that can embed and execute a cel script.
It's a working solution, surely, but it is tuned for people using celx, more than for who uses only cel scripts.
So my request:
could someone be so kind and smart to add a cel script allowing the switching ON and OF of the various Reference Marks, separately?
And (this would be a real wonder) a script allowing to embed a celx script within a cel script?
I mean to have a cel script that makes actions and, at a certain point, launches the celx script, that makes other actions, and at its end returns back to the cel script, that will make other actions, and then finish.
This would be a real wonder, but don't know if it can even be possible so....
Thank you for your patience.
Bye
Goofy
"
