I followed this procedure:
1- using "Jim" Jens Meyer's spreadsheet VT-tile-calculator, I found the image codes for the relevant area, for both levels 11 and 12;
2- using PhotoShop CS2 I converted to .jpg the single kinderino's 2048x2048 level10 image, divided it in four 1024x1024, and resized each ot these to 4 2048x2048 level11 images;
3- found the right one, I pasted on it the hiresimage, with same resolution as level11, and saved it as level11;
4- divided it in four 1024x1024 images, and resized each ot these to four 2048x2048 level12 images;
5- on the right one I pasted the original hires image, with the same resolution of the level12 one.
At this point I had four level11 and one level12 images, that I converted again to .dds format using XNView 1.83, and put in the level11 and level12 subdirectories of BlueMarble DDS.
The problem is that I don't reach those levels, when I go closer nothing happens.
I use CelestiaFT1.2 and latest Nvidia drivers.
Where did I make a mistake?
Don't think it's in converting dds to jpg and viceversa, my new .dds filea are all 2049kb, like kinderino's level10 dds files.
The exact coordinates of my hires image center are:
longitude 12.33800 latitude 45.41900 and here the file names containing these coordinates:
tx_1094_253.dds level10
tx_2190_520.dds level11
tx_4381_1039.dds level12.
Please help me, I was enjoyng doing this, and would like to go on.
Bye and thank you
Andrea
